59
Specications are subject to change without prior notication December 2019
16 Problem Solving
PROBLEM CAUSE REMEDY
Machine ripping deeper on one side Trailed machine wheel rams not rephased Bleed system for at least 1 to 3 minutes to ensure all
air is expelled
Linkage machine bottom link arms incorrectly adjusted Ensure these are level during operation
Uneven tyre pressure Inate to correct pressure
Loss of penetration Some soil types may produce bottom wear, thick hard pan,
or varying depth causing variations in performance.
Reverse points, and ensure that machine is level at
working depth
Conditions too hard It my be necessary to wait until conditions are more
suitable
Damage to Deep Digger at tines at point Machine pitch angle incorrectly set, (nose down) over
loading points.
Ensure machine is level in working situation especially
in root bound pasture conditions
Machine being used to lever rocks and stumps Stop! The machine is not designed for this operation.
Damage caused as a result will not be covered by
warranty
Rapid point wear Excessive speed Wait until conditions are more suitable. Slow down!
Abrasive soil type Keep spare points on hand
Install hard faced points
Machine 'bounces' in operation Tyre pressure too low Inate to correct pressure (see assemby instructions)
To Next Page
Loading...
Need help?
General