-18-
G0458 18" Open End Belt/Drum Sander
Recommended
Adjustments
For your convenience, the adjustments listed
below have been performed at the factory and
no further setup is required to operate your
machine.
However, because of the many variables involved
with shipping, some of these adjustments may
need to be repeated to ensure optimum results.
Keep this in mind as you start to use your new
drum sander.
Step-by-step instructions for these adjust
-
ments can be found in SECTION 7: SERVICE
ADJUSTMENTS.
1. V-Belt Tensioning (Page 27). Perform after
the first 16 hours.
2. Feed Belt Tensioning & Tracking (Pages 31
& 32).
3. Table Adjustments (Page 34).
To Next Page
Loading...
Need help?
General
