BdYZa<%,&*EB[\#)$&&
"'*"
Figure 25.9jhi]dhZViiVX]ZYidYjhiedgi#
DO NOT operate the Model G0715P without
an adequate dust collection system. This
saw creates substantial amounts of wood
dust while operating. Failure to use a dust
collection system can result in short and
long-term respiratory illness.
Recommended CFM at Dust Port: 400 CFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
Dust Collection
To connect a dust collection hose:
1. ;^i V ) Yjhi ]dhZ dkZg i]Z Yjhi edgi! Vh
h]dlc ^cFigure 25!VcY i^\]ian hZXjgZ ^i^c
eaVXZl^i]V]dhZXaVbe#
2. Ij\i]Z]dhZidbV`ZhjgZ^iYdZhcdiXdbZ
d[[# Note: A tight fit is necessary for proper
performance.
Components and Hardware Needed: Qty
9jhi=dhZ)cdi^cXajYZY###############################&
=dhZ8aVbeh)cdi^cXajYZY##########################'
9jhi8daaZXi^dcHnhiZbcdi^cXajYZY###############&
To Next Page
Loading...
Need help?
General
