Grizzly G0941 - Cutting a Zero Clearance Insert



5. 
        
        
      Figure 58 
       

6. 
 Suggestion To retain the zero clearance
ability of the insert included with this saw, we
recommend only raising the blade into the
insert at 90° during the following step.
       


Page 61 
Step 7.




Page 61Step 7



      
Step 7

Figure 57
7.        


8.ON


Figure 58.




1. 
2.        
      Blade
Installation Page 37
3.        Figure
57
Cutting a Zero
Clearance Insert

       



To install the zero clearance insert:
4.        




Figure 57.






8.OFF

9.       
Page 38.