Grizzly G8749 - Maintenance Schedule and Procedures; Maintenance Schedule; Cleaning the Sander; Lubrication Requirements



SECTION 6: MAINTENANCE
Always disconnect power
to the machine before
performing maintenance.
Failure to do this may
result in serious person-
al injury.
     


Daily Check:
 
 
 
 
 
Daily Maintenance:
• 
Schedule
      
      



Cleaning
Lubrication

       

Replacing Sanding
Sleeves
       

  




To replace the sanding sleeve:
1. 
2.       

Figure 20

Figure 20.



3.       
      

 Note: Make sure the sanding sleeve does not
extend beyond either end of the drum.
4. 
       

