Replacing Flap
Sandpaper/Brushes
To replace the flap sandpaper or brushes:
1.
2.
3.
Note: All of the replacement sandpaper
needs to be oriented and installed so that
the abrasive side faces the same direction
and will face forward and down when the flap
sander is properly mounted on the machine.
4.
5.
Figure 21
6.
7.
Figure 22
Figure 21.
8.
9.
Note: When storing the flap sander in a dry,
protected place, secure the bottom and top
end plates with tie wraps or string so that the
end plates do not come loose and allow the
brushes to fall out.
Figure 22.
To Next Page
Loading...
