The information contained herein is deemed accurate as of 10/7/2008 and represents our most recent product specifications.
Due to our ongoing improvement efforts, this information may not accurately describe items previously purchased.
PAGE 2 OF 3Model G9967
Cutterhead
Type.................................................................................................................. TEFC Capacitor Start Induction
Horsepower.................................................................................................................................................5 HP
Voltage........................................................................................................................................................220V
Prewired......................................................................................................................................................220V
Phase........................................................................................................................................................Single
Amps.............................................................................................................................................................28A
Speed.................................................................................................................................................3450 RPM
Cycle..........................................................................................................................................................60 Hz
Number Of Speeds........................................................................................................................................... 1
Power Transfer ...................................................................................................................................Belt Drive
Bearings....................................................................................................................... Shielded and Lubricated
Main Specifications:
Operation Info
Max. Cut Width...........................................................................................................................................20 in.
Max. Cut Height............................................................................................................................................9 in.
Min. Stock Length......................................................................................................................................10 in.
Min. Stock Width....................................................................................................................................... 1/4 in.
Max. Stock Thickness.................................................................................................................................. 9 in.
No. Of Cuts Per Inch................................................................................................................................42 - 84
No. Of Cuts Per Minute.............................................................................................................................20000
Cutterhead Speed..............................................................................................................................5000 RPM
Planing Feed Rate...........................................................................................................................20 - 40 FPM
Max. Cut Depth Planing Full Width......................................................................................................... 3/16 in.
Max. Cut Depth Planing 6 Inch Wide Board............................................................................................5/16 in.
Cutterhead Info
Cutterhead Type...................................................................................................................................... 4 Knife
Cutterhead Dia.......................................................................................................................................4-5/8 in.
No. Of Knives....................................................................................................................................................4
Knife Type....................................................................................................................................................HSS
Knife Size Length.................................................................................................................................20-1/8 in.
Knife Size Width...................................................................................................................................1-3/16 in.
Knife Size Thickness.................................................................................................................................1/8 in.
Knife Adjustment............................................................................................................. Gibs and Jack Screws
Table Info
Table Movement.................................................................................................................................. 1/4 - 9 in.
Table Bed Size Length...............................................................................................................................24 in.
Table Bed Size Width...........................................................................................................................35-1/2 in.
Table Bed Size Thickness............................................................................................................................5 in.
No. Of Bed Rollers............................................................................................................................................ 2
Floor To Table Height......................................................................................................................... 24 - 33 in.
Construction
Table Construction...................................................................................................Precision Ground Cast Iron
Body Construction................................................................................................................................ Cast Iron
Cutterhead Assembly Construction.... One Piece Machined Steel Shaft; 4 Knife Slots; Shielded Ball Bearings
Infeed Roller Construction.......................................................................................................Segmented Steel
Outfeed Roller Construction.........................................................................................................Polished Steel
Paint..........................................................................................................................................................Epoxy
Other
Table Locks.................................................................................................................................... One Positive
Measurement Scale....................................................................................................................Inch and Metric
No. Of Dust Ports..............................................................................................................................................1
Dust Port Size.............................................................................................................................................. 5 in.
To Next Page
Loading...
