H5503 14 Gauge Swivel Head Shears
-8-
Cleaning Shear
Use a good solvent to clean the jaw
assembly of the shear. Avoid getting sol-
vent on the plastic body of the shear as it
may damage the plastic. Always be sure
that the shear is dry before using it again.
Do not allow dust, chips, sand, etc. into the
air vent holes. This could lead to motor fail-
ure and premature bushing failure.
Never use use gasoline or other flam-
mable liquids to clean this tool.
Vapors in the tool may ignite, causing
the tool to explode. Ignoring this
warning may lead to serious personal
injury or even death!
Basic Care
The following should be performed on the
tool when applicable:
• Blow off dirt, dust and debris from the
tool and out of the air vents.
• Maintain a sharp edge on your blades
for the best performance.
• Clean the power cord and coil it neatly
when the tool is not in use.
• Repair or replace damaged parts.
• Keep the blade safety cover on when
the tool is not in use.
To Next Page
Loading...
Need help?
General
