OM-BPM-G
WARNING
DO NOT SPRAY WATER DIRECTLY ON
BURNERS AND GAS COMBUSTION
CHAMBERS.
7. The exterior surface of the unit may be polished
with a recognized stainless steel cleaner.
NOTICE
NEVER LEAVE A CHLORINE SANITIZER IN
CONTACT WITH STAINLESS STEEL SURFACES
LONGER THAN 30 MINUTES. LONGER
CONTACT CAN CAUSE CORROSION.
8. If the equipment needs to be sanitized, use a
sanitizing solution equivalent to one that supplies 100
parts per million available chlorine. Obtain advice on
the best sanitizing agent from your supplier of
sanitizing products. Following the supplier's
instructions, apply the sanitizing agent after the unit
has been cleaned and drained. Rinse off the sanitizer
thoroughly
.
9. If there is difficulty removing mineral deposits or a
film left by hard water or food residues, clean the pan
thoroughly and then use a deliming agent, such as
Groen De-limer/De-Scaler (P/N 140513), in
accordance with the manufacturer's directions. Rinse
and drain the unit before further use.
10. If especially difficult cleaning problems persist,
contact your cleaning product representative for
assistance.
Maintenance
Your Braising Pan is designed to require minimum
maintenance, but certain parts may need replacement
after prolonged use. After installation, no user
adjustment should be necessary. If a service need
arises, only authorized personnel should perform the
work.
WARNING
ELECTRIC POWER ALWAYS SHOULD BE
SHUT OFF BEFORE WORK IS DONE ON
INTERNAL COMPONENTS.
Service personnel should check the unit at least once
a year. This periodic maintenance should include
inspecting electrical wires and connections,
cleaning the inside of the control console, and possible
adjustment of the pilot light. (Units with
.
standing pilot ignition only) At least twice a year,
grease the two trunnion bearings and worm gear
Groen recommends the use of number two grade LGI
lithium grease. Add grease through the zerk fittings on
the gear hosing until grease flows out of the bearings
around trunnion shaft. Also, add grease in the gear to
cover arc that is in contact with the worm gear. Clean
up excess grease.
WARNING
DISCONNECT ELECTRICAL POWER FROM
THE UNIT BEFORE ATTEMPTING TO GREASE
THE TRUNNION BEARINGS.
A Service Log is provided with the warranty information
at the back of this manual. Each time service is
performed on your Groen equipment, enter the date on
which the work was done, what was done, and who did
it. Keep the manual with the equipment for quick and
easy reference.