- 22 -
Fig.5.1.7 Fig.5.1.8
4) Connect it to the inverter as Fig.5.1.8.
C. AC connector 3:
Assembly procedure:
1) The AC side terminals of the inverter are like Fig.5.1.9, it is clear to confirm that ‘L1, L2, L3’
represents three live line output, ‘N’ represents neutral line and is grounding line.
2) Connect five standard cables into relevant terminals. The five cables should be put through the
protection shell, as Fig.5.1.10.
Fig.5.1.9 Fig.5.1.10
3) Fasten the protection shell onto the bottom of the inverter, make sure the four screws are
tightened, the completed appearance is like Fig.5.1.11.
To Next Page
Loading...
