Ø Ensure all connectors are sealed and secured during operation.
Ø Although designed to meet all safety requirements, some parts
and surfaces of the inverter are still hot during operation. To
reduce the risk of injury, do not touch the heat sink at the back of
the PV-inverter or nearby surfaces while the inverter is in
operation.
Ø Incorrect sizing of the PV panels may result in high voltages that
could damage the inverter. In this case, the inverter will display
the error message "PV Voltage High".
Ø All operations regarding transportation, installation, start-up
and maintenance must be operated by qualified, trained
personnel and in compliance with all prevailing codes and
regulations.
Ø After the system powers off, take great caution as the remaining
charge may still cause electrical shocks; to minimize the risk of
accidents and damage, follow all safety symbols and markings on
the unit and in this manual.
Ø Although standardized emission limit values are in place to
minimize interference, certain situations may still result in
interference for the specified application area. This can happen
when sensitive equipment is located near the setup location, or
when the setup location is near radio or television receivers. In
these cases, the operator is responsible for taking appropriate
measures to resolve the issue.
Ø Keep a safe distance of at least 20cm from the inverter at all
times.
To Next Page
Loading...
