Growatt MID TL3-XH Series - Page 38

9.3.1 Setting the export limitation parameter
The -XH series inverters support the export limitation function when working with an
external power meter or CT. Users can configure the parameter on the OLED screen.
Single tap to view the options available or increase the number by one; double tap to
confirm your setting. Set the export limitation parameter as shown below:
9.3.2 Restoring to factory settings
33 34
OFF ON OFF ON
OFF ON
Double tap
Single tap
OK
Export Limit Rate
000.0%
000.0%
0N0.0%
0N0.0%
0NN.0%
OK
100.0%
010.0%
0N1.0%
0NN.0%
0NN.N%
0NN.1%
Country/Area
VDE0126
Password
123
General
Advanced
Export Limit
9.3.3 Setting the backup mode (Off-grid models only)
Restore to factory
settings
NO
YES
NO
YES
OK
Double touch
Password
123
Country/Area
VDE0126
General
Advanced
Backup Setting
Disable
AC Volt
208V
AC Volt
AC Freq
50Hz 60Hz
AC Freq
50Hz 60Hz
Backup Box
Disable
OK
Country/Area
VDE0126
Password
123
General
Advanced
Backup Box
Disable
Backup Box
Enable
Backup Setting
Disable
Backup Setting
Enable
220V
AC Volt
230V
AC Volt
240V
Double tap
Double tap
Double tap
Double tap
Double tap
Double tap
Export Limit
Meter
CT
Export Limit Rate
Single tap
Double tap
Double tap
Multi-tap
Export Limit Rate
Export Limit Rate
Export Limit Rate Export Limit Rate
Export Limit Rate
Export Limit Rate Export Limit Rate
Export Limit Rate
Export Limit Rate
Double tap
Double tap
Double tap
Double tap
Double tap
Double tap
Double tap
Double tap
Double tap
Single tap Single tap Single tap
Multi-tap Multi-tap Multi-tap
Take caution because after this operation, all parameters excluding the
current date and time, will restore to the default factory settings.
Information
Single tap to view the options available or increase the number by one; double tap to
confirm your setting.
Double tap
Double tap
Double tap
Double tap
Single tap
Multi-tap
Working with the battery and the backup box, the -XH series inverters can operate in
backup mode to supply power to loads when the grid fails. The maximum output power
is equal to the inverter's rated power. You can configure the output voltage (set to
230V/400V by default) and the output frequency (set to 50HZ by default) for the backup
mode. If the backup mode is disabled (the inverter stops power output when the grid is
lost), you can enable the backup mode on the OLED screen. Single tap to view the
options or increase the number by one; double tap to confirm your setting. Configure the
backup mode as shown below:
Double tap
Double tap
Double tap
Double tap
Double tap
Double tap Double tap Double tap
Double tap
Double tap
Double tap
Double tap
Double tap
Single tap
Single tap
Single tap
Double tap
Single tap
Single tap
Single tap
Single tap
Single tap
Multi-tap
OK
OK
OK
Phase Level