> Ensure all connectors are sealed and secure during operation.
> Although designed to meet all safety requirements, some parts and
surfaces of inverter are still hot during operation. To reduce the risk of
injury, do not touch the heat sink at the back of the PV- inverter or
nearby surfaces while inverter is operating.
> Incorrect sizing of the PV panels may result in voltages being present
which could destroy the inverter. The inverter display will read the er-
ror message "PV voltage High!"
> All operations regarding transport, installation and start-up, including
maintenance must be operated by qualified, trained personnel and in
compliance with all prevailing codes and regulations.
> When the inverter is disconnected from the grid, please be careful be-
cause some components can retain enough charge to create a shock
hazard. In order to minimize the occurrence of this situation,observe
all corresponding safety symbols and marks in this manual.
> Under special circumstances, the inverter may be subject to electro-
magnetic interference from surrounding equipment. At this time, the
user is obliged to take correct measures to reduce the interference
from surrounding equipment to the inverter.
> Do not stay close to the inverter less than 20cm at anytime.
To Next Page
Loading...
Need help?
General