3.6 Changing the pump head position
WARNING
Electric shock
Death or serious personal injury
‐ Switch off the power supply before you start any work on the
product. Make sure that the power supply cannot be switched on
accidentally.
WARNING
Hot surface
Death or serious personal injury
‐ At high liquid temperatures, the product may become so hot that
only the operating panel must be touched to avoid burns. Close
the isolating valves on all sides of the product and then drain
it. Wear protective gloves.
To change the orientation of the pump head, do as follows:
1. Use a wrench to loosen the union.
TM075635
2. Carefully turn the pump head to the desired position and tighten the union
(max. 20 Nm). Open the isolating valves.
TM075636
12
English (US)
To Next Page
Loading...
