Pos. Description
4
Operating time LEDs.
These LEDs indicate the pump's operating periods. One LED
equals an interval of 30 minutes.
When setting the operating time, the applicable LEDs flash
green.
5
Change button for changing the actual time and operating times
when in setting mode.
6
Actual time.
One LED equals an interval of 30 minutes.
The LED is permanently on when set. It flashes yellow when not
set.
7 OK button for confirming, changing or deleting settings.
8
Timer mode.
When lit, the LED indicates that the timer mode is activated.
9
Pump operation LED.
It indicates that the pump is operating.
10
QR code.
Scan the QR code for access to additional product information
and documentation.
Timer control mode
The pump operates continuously based on set operating times.
In case of a power failure, the time pauses with no power reserve. However,
the selected operating times and actual time are retained. When power is
restored, the pump resumes its last set operating state. If the power outage
exceeds 15 minutes, the actual time may need to be reset.
Timer and temperature control mode
The pump operates based on set operating times and temperature mode.
Temperature mode is therefore only enabled during the set operating times.
Comfort is ensured via an internal sensor for more accurate water temperature
measurement. The pump can automatically adjust on/off temperatures based
on the maximum temperature measured in the system. For example, if the
17
English (US)
To Next Page
Loading...
