Need help?Do you have a question about the Grundfos DDA 12-10 and is the answer not in the manual?
General| Flow rate | 12 l/h |
|---|---|
| Pressure | 10 bar |
| Power consumption | max 36 W |
| Protection class | IP65 |
| Analog control signal | 0/4-20 mA |
| Max Flow Rate | 12 l/h |
| Max Head | 10 bar |
| Voltage | 100-240 V AC |
| Frequency | 50/60 Hz |
| Phase | 1 |
| Operating temperature | 0 - 45 °C |
| Housing Material | Plastic |
| Seal Type | PTFE |
| Power supply | 1 x 100-240 VAC, 50/60 Hz |
Details required qualifications and training for personnel.
Provides safety guidelines for users operating the pump.
Outlines system safety measures during pump failure.
Safety precautions when handling dosing chemicals.
Hazards and actions related to diaphragm breakage.
Step-by-step guide for mounting pump, including plate installation, engagement, and control cube adjustment.
Instructions for connecting the pump's hydraulic lines.
Steps for making the electrical connections to the pump.
Steps to calibrate the pump for accurate dosing.
Describes the different modes for pump operation.
Schedule and tasks for routine pump maintenance.
General instructions and precautions for performing service.
Hazards and procedures for diaphragm leakage/breakage, including dismantling and liquid entry.
Comprehensive list of possible faults and their remedies.
To Next Page