Need help?Do you have a question about the Grundfos Magna 25-60 Series 2000 and is the answer not in the manual?
General| Brand | Grundfos |
|---|---|
| Model | Magna 25-60 Series 2000 |
| Category | Water Pump |
| Language | English |
EU Directive on machinery safety.
EU Directive on EMC.
EU Low Voltage Directive.
General description of the GRUNDFOS MAGNA Series 2000 pumps.
Describes suitable applications for the pumps.
Lists acceptable fluids for pumping.
Procedure for rotating the control box.
Installation requirements for twin pump configurations.
Considerations for installing a non-return valve.
Measures to protect the pump from frost.
Specifies the voltage requirements for the pump.
Instructions for wiring the pump to the power supply.
How to avoid issues from condensate in the terminal box.
Functions accessible via the pump's control panel.
Functions controllable using the R100 remote.
Overview of pump expansion modules and their functions.
Details on the Rele module's functions.
Details on the GENI module's functions.
Guidance on choosing the appropriate pump control mode.
How to set the desired operating point for the pump.
Description of the automatic energy-saving night mode.
Operation based on a fixed performance curve.
Operating the pump using maximum or minimum curves.
How fluid temperature affects pump performance.
Overview of pump expansion modules.
Details on the Rele module's functions.
Details on the GENI module's functions.
Configuration and operation of twin pump systems.
Selecting operating modes for twin pumps.
How to connect the pump to a LON network.
Description of the pump's control panel interface.
How to select the pump's operating mode via control panel.
Adjusting the pump's operating point using the control panel.
Adjusting max curve setting via control panel.
Adjusting min curve setting via control panel.
How to start and stop the pump using the control panel.
How to acknowledge and clear fault messages.
Using the R100 remote control for pump operations.
Setting the desired operating point via R100.
Selecting the pump's operating mode via R100.
Displaying current fault information on R100.
Accessing the recorded history of pump faults.
Displaying the pump's current setpoint.
Displaying the current operating mode.
Showing current head and flow rate.
Displaying the pump's current rotational speed.
Displaying the temperature of the pumped fluid.
Displaying the pump's power usage.
Displaying the total operating hours of the pump.
Configuring the pump's control mode via R100.
Enabling/disabling automatic night setback via R100.
Adjusting temperature influence on pump performance via R100.
Enabling/disabling pump's physical buttons via R100.
Configuring the signal relay function via R100.
Assigning a unique number to the pump via R100.
Procedure for checking the status of pump modules.
Voltage, motor protection, insulation class, leakage current.
Humidity, ambient temperature, fluid temperature.
System pressure, inlet pressure, sound level, EMC.
To Next Page