Grundfos MGE 71 - Basic Control Panel; Standard Control Panel; 8 User Interfaces

English (GB)
15
8. User interfaces
Motor settings can be made by means of the following user
interfaces:
Control panels
• Basic control panel.
See section 8.1 Basic control panel.
• Standard control panel.
See section 8.2 Standard control panel.
Remote controls
• Grundfos R100 remote control.
See section 8.4 R100 remote control.
• Grundfos GO Remote.
See section 8.5 Grundfos GO Remote.
If the power supply to the motor is switched off, the motor settings
will be stored.
8.1 Basic control panel
Fig. 17 Basic control panel
8.1.1 Settings
All settings are to be made with the Grundfos R100 or Grundfos
GO Remote.
8.1.2 Resetting of alarms and warnings
A fault indication can be reset in one of the following ways:
• Via the digital input if it has been set to "Alarm resetting".
• Switch off the power supply until the indicator lights are off.
• Switch the external start/stop input off and then on again.
• With the R100. See section Alarm, page 19.
• With the Grundfos GO Remote.
8.2 Standard control panel
Fig. 18 Standard control panel
Warning
The product may be so hot that only the buttons
should be touched to avoid burns.
TM05 4847 2712
Pos. Symbol Description
1
Grundfos Eye
Shows the operating status of the motor.
See section 12. Grundfos Eye for further
information.
2
Enables radio communication with the
Grundfos GO Remote and other MGE motors
of the same type.
1
2
TM05 4848 3512
Pos. Symbol Description
1
Grundfos Eye
Shows the operating status of the motor.
See section 12. Grundfos Eye for further
information.
2 - Light fields for indication of setpoint.
3 Changes the setpoint.
4
Enables radio communication with the
Grundfos GO Remote and with other MGE
motors of the same type.
5
Makes the motor ready for operation/starts
and stops.
Start:
If the button is pressed when the motor is
stopped, the motor will only start if no other
functions with higher priority have been
enabled. See section 11. Priority of
settings.
Stop:
If the button is pressed when the motor is
running, the motor will always be stopped.
When the motor is stopped, the "Stop" text
next to the button will illuminate.
1
2
3
4
5
Stop