Grundfos MGE 71 - Remote Control Operations (R100); R100 Menu Structure Overview

English (GB)
18
8.4 R100 remote control
The motor is designed for wireless communication with the
Grundfos R100 remote control.
Fig. 29 R100 communicating with the motor via infrared light
During communication, the R100 must be pointed at the control
panel. When the R100 communicates with the motor, the
indicator light in the middle of the Grundfos Eye will flash green.
See page 30.
The R100 offers additional possibilities of setting and status
displays for the motor.
The displays are divided into four parallel menus:
0. GENERAL (see operating instructions for the R100)
1. OPERATION
2. STATUS
3. INSTALLATION.
See section 8.4.1 R100 menu structure.
8.4.1 R100 menu structure
TM05 3933 1712
0. GENERAL 1. OPERATION 2. STATUS 3. INSTALLATION
Switch off R100 Setpoint
Actual setpoint and
external setpoint
Control mode
Return to start Operating mode Operating mode Controller
Delete all changes Manual speed Actual controlled value Signal relay 1 and 2
Store settings Alarm Analog input 1, 2 and 3 Buttons on motor
Call up settings Warning Pt100/1000 input 1 and 2 Number
Store status data Alarm log 1 to 5 Speed Radio communication
Call up status data Warning log 1 to 5
Power input and power
consumption
Digital input 1 and 2, Function
Operating hours Digital input/output 3 and 4, State
Replace motor bearings
Digital input/output 3 and 4,
Function
Motor current Analog input 1, 2 and 3, Function
Analog input 1, 2 and 3, Measured
parameter
Analog input 1, 2 and 3
Pt100/1000 input 1 and 2, Function
Pt100/1000 input 1 and 2, Measured
parameter
Operating range
Ramps
Direction of rotation
Skip band 1
Skip band 2
Motor bearing monitoring
Motor bearings
Standstill heating