16
8.1 R100 menus
0. GENERAL
See operating instructions for the R100.
1. OPERATION
• Operating mode
•Actual trip
• Actual warning 1
• Actual warning 2
• Alarm log 1
• Alarm log 2
• Alarm log 3
• Alarm log 4
• Alarm log 5.
2. STATUS
Display of
• Supply overview
• Average current
• Average voltage
• Tempcon sensor
• Pt100/Pt1000 sensor
• Power input and energy consumption
• Energy trip counter
• Phase sequence
• Current unbalance
• Operating hours and number of starts
• Trip counter of hours and starts
• Starting capacitor
• Run capacitor
• Insulation resistance
•Cos ϕ
• Harmonic distortion.
3. LIMITS
Display and setting of warning and trip limits.
• Tempcon sensor
• Pt sensor
• Tripping current
• Current warning
• Nominal voltage
• Voltage limits
• Current unbalance
• Starting capacitor
• Run capacitor
• Insulation resistance
•Cos ϕ trip
•Cos ϕ warning.
4. INSTALLATION
Setting and display of
• Supply mains
•Trip class
• Trip delay
• External current transformers
• Power-on delay
•Restarting
• Automatic restarting
• Tempcon sensor
• Pt sensor
• Insulation resistance measurement
• PTC/thermal switch
• Resetting of trip counters
• Service interval
• Number of automatic restarts
• Units/display
•MP204 display
• GENIbus ID number
• Learning function.
To Next Page
