English (GB)
10
English (GB) Safety instructions
Original safety instructions.
CONTENTS
Page
1. Symbols used in this document
2. Radio communication
This product incorporates a radio module for remote
control which is a class 1 device and can be used
anywhere in the EU member states without
restrictions.
For use in USA and Canada, see page 63.
This product can communicate with the Grundfos
GO Remote and with other products of the same
type via the built-in radio module.
In some cases, an external antenna may be
required. Only Grundfos-approved external antennas
may be wconnected to this product, and only by a
Grundfos-approved installer.
3. Installation
1. Symbols used in this document
10
2. Radio communication
10
3. Installation
10
4. Electrical connection
11
5. Setting via the control panel
11
6. Working on the product
11
6.1 Megging
11
7. Further product information
11
8. Disposal
11
Warning
Prior to installation, read this
document and all other documents
supplied with the product, including
the electronic version of the
installation and operating instructions
supplied on a USB stick or as an online
document. See section 7. Further
product information.
Installation and operation must comply
with local regulations and accepted
codes of good practice.
Warning
If these safety instructions are not
observed, it may result in personal
injury.
Warning
If these instructions are not observed,
it may lead to electric shock with
consequent risk of serious personal
injury or death.
Warning
The surface of the product may be so
hot that it may cause burns or personal
injury.
Warning
Risk of dropping objects which may
cause personal injury.
If these safety instructions are not
observed, it may result in malfunction
or damage to the equipment.
Notes or instructions that make the job
easier and ensure safe operation.
Some variants of these products and
all products sold in China and Korea
have no possibility of radio
communication according to local
legislation.
Warning
Installation and operation must comply
with local regulations and accepted
codes of good practice.
The motor must not be installed more
than 2000 metres above sea level.