EasyManua.ls Logo

Grundfos UNILIFT KP 150 A - Product Introduction; Intended Use; Pumped Liquids

Grundfos UNILIFT KP 150 A
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5. Product introduction
Grundfos UNILIFT KP pumps are available in these versions:
UNILIFT KP-A
Automatic start/stop operation via a float
switch.
UNILIFT KP-AV
Automatic start/stop operation via a vertical
level switch.
UNILIFT KP-M
Manual operation via an external on/off
switch, without a level switch.
A
B
TM011107
Pumps with a level switch
Pos. Description
A UNILIFT KP-A with float switch
B UNILIFT KP-AV with vertical level switch
1 Outlet, Rp 1 1/4
2 Handle
3 Cable clamp
4 Inlet strainer
5 Pump sleeve
6 Float switch
7 Vertical level switch
5.1 Intended use
The Grundfos UNILIFT KP pump is a single-stage submersible
pump designed for pumping grey wastewater, that is, wastewater
from showers, sinks, washing machines, etc.
The pump is capable of pumping water which contains a limited
quantity of solids, however not stones and similar materials, without
being blocked or damaged.
The pump is available for automatic as well as manual operation
and can be installed in a permanent installation or used as a
portable pump.
Applications
KP 150
KP 250
KP 350
Drainage of flooded cellars or buildings
Groundwater lowering
Pumping of water from drain water collecting
tanks and pits
Pumping of water from surface water tanks and
pits with inflow from roof gutters, shafts, tunnels,
etc.
Emptying and filling of swimming pools, ponds,
tanks, etc.
Pumping of wastewater from washing ma-
chines, baths, sinks, etc. from cellars up to sew-
er level
Incorrect application of the pump, for example resulting in blocking
of the pump, and wear are not covered by the warranty.
5.2 Pumped liquids
The pump is capable of pumping wastewater containing a limited
quantity of spherical particles. Pumping of spherical particles
exceeding the maximum particle size for the pump may block or
damage the pump.
Maximum particle size: See section 8.1 Storage temperature.
The pump is not suitable for these liquids:
sewage
liquids containing long fibres
flammable liquids (oil, petrol, etc.)
aggressive liquids
liquids containing solids exceeding the pump's recommended
maximum particle size.
The pump contains approx. 70 ml of non-toxic motor liquid
which will be mixed with the pumped liquid in case of a
leak.
11
English (GB)

Related product manuals