Grundig 32 VLC 6110 C - Setting the Date and Time; Timer Settings

ENGLISH
32
CONVENIENCE FUNCTIONS
------------------------------------------------------------------------
Setting the date and time
Automatic setting
Your television set detects the difference in time
to Greenwich Mean Time (GMT) automatically,
as long as the channel selected transmits a time
signal.
1 Select the line »Time Adjustment« with »
V «,
then select the option »Manual« with »
<
«
or »
>
«.
– The lines »Time Zone« and »Daylight Sav-
ing« are active.
2 Select the line »Time Zone« with »
V « and
press
»OK« to confirm.
– The »Select Time Zone« menu appears.
3 Select the appropriate time zone with »
<
«,
»
>
«, » V « or » Λ « and press »OK« to con-
firm.
4 Select the line »Daylight Saving« with »
V «
and use »
<
« or »
>
« to set the option »Auto«,
»Off« or »On«.
5 Press »
MENU« to finish the setting.
Manual setting
You can also set the difference in time manually
– for example, when the correct time is not de-
tected automatically or does not correspond to
local time for other reasons
1 Select the line »Date & Time« with »
V « or
»
Λ « and press »OK« to confirm.
2 Select the line »Auto« with »
V « or » Λ « and
press
»OK« to confirm.
– Date and Time will be updated
automatically;
or
3 Select the input box with »
V « or » Λ «, enter
the data for Date and Time with »1...0«
and press
»OK« to confirm.
Timer settings
Entering the switch-off time
(sleep timer)
In the »Sleep Timer« menu you can enter a time
for the television to switch off. After this time
has elapsed, the television switches to standby
mode.
1 Select the line »Sleep Timer« with »
V « or
» Λ «.
2 Enter the switch-off time with »
<
« or »
>
«.
Note:
7
To switch off the function, use »
<
« or »
>
« to
set the switch-off time to »Off«.
3 Press »
MENU« to end the set-up.
Switch-on timer
In the »Auto On« menu you can enter a switch-on
time for the television. After the preset time has
elapsed, the television switches on from standby
– at the preselected volume and the preselected
television channel.
1 Select the line » Auto On « with » V « or » Λ «
and press
»OK« to confirm .
2 Select the line »Mode« with » V « or » Λ « and
use »
<
« or »
>
« to select when the television
should switch on.
3 Select the line »Input Source« with
» V « or » Λ «
and use »
<
« or »
>
« to select the input source.
4 Select the line »Service Type« with
» V « or » Λ «
and use »
<
« or »
>
« to select the preferred op-
tion (ATV, DTV, Radio or DATA).
5 Select the line »Channel« with
» V « or » Λ «
and use »
<
« or »
>
« to select the preferred
channel.
Note:
7
The line »Channel« is only active when the in-
put signal currently in use has been set. If no
entry has been made, then the first channel of
the selected input source will be used.