EasyManua.ls Logo

Grundig MS240 - AUX MODE; Listening to an External Source

Grundig MS240
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
25
ENGLISH
CASSETTE MODE
-----------------------------------------------------------------------------------------------------------
Selecting the cassette input
source
1 Select the cassette input source with »SOURCE«
on the hi-fi system or »CASS« on the remote con-
trol.
Playback
1 Open the front flap which is marked with
»OPEN« on the front panel.
2 Press »7
J
« to open the tape compartment.
3 Insert a cassette in the compartment with the
open side facing downwards and the full reel
on the left side and close the compartment.
4 Press »8« to start playback.
– The button is automatically released at the
end of the tape, except if pause function has
been activated.
5 To pause playback press »II« and resume
playback by pressing »II« again.
6 End playback with »7
J
«.
Note:
7
The source cannot be changed while play-
ing or recording a cassette.
Fast forward and reverse search
1 In stop mode, press »3« or »4«.
– »3« rewinds to the beginning, »4«
fast forwards to the end.
Recording onto cassette
Erase protection
Each new recording writes over the previous re-
cording.
You can protect your recordings against inad-
vertent deletion by breaking the protection tab in
the opening in the spine of the tape.
Purchased recordings on music tapes are al-
ready protected against accidental deletion.
If you wish to record on a protected tape, seal
the opening with adhesive tape.
Notes:
7
Only use NORMAL-type cassettes (IEC I) for
recording. CHROME (IEC II) or METAL (IEC
IV) tapes are not suitable.
7
The Ultra Bass System does not affect re-
cording.
AUX MODE
--------------------------------------------------------------------------------------------------------------------------------
Listening to an external source
You can listen to the sound of the connected ex-
ternal device (e.g. a MP3 player) through your
system’s speakers.
1 Select the AUX source with »SOURCE« on the
hi-fi system or » AUX« on the remote control.
2 Use a standard audio adapter (not supplied)
to connect »AUX In« socket (ø 3.5 mm ) on
the back of the hi-fi system to an »AUDIO
OUT« or »U« headphone socket on an exter-
nal equipment (such MP3 player).