What does it mean when my GSE 350 Touch Panel displays 'Input signal greatly exceeds the valid range'?
This message indicates that the input signal is far beyond what is expected. To resolve this, check the load cell connection of your GSE Touch Panel.
What to do if my GSE 350 displays 'Under Load'?
If your GSE Touch Panel displays 'Under Load', check the load cell wiring.
What to do if my GSE Touch Panel displays 'Trans~Hold2'?
This message on the GSE Touch Panel indicates that data transmission is being blocked because of a deasserted handshake on communication port 2. To resolve this, press the [ZERO] or [CLR] button to stop the transmission and then check P204.
What does 'F.S. ~ TooHi' mean on GSE Accessories?
The message 'F.S. ~ TooHi' on GSE Accessories means that the entered calibration weight will result in an over-capacity condition at full scale. Verify that the full scale (P110) and calibration weight value are correct.
What does 'A-D ~ Bad!' mean on GSE Accessories?
The message 'A-D ~ Bad!' on GSE Accessories indicates a problem with the A/D chip. Disconnect any Or Code17 options installed and re-power the unit.
What does 'T.X.YYYY' mean on GSE Accessories?
The message 'T.X.YYYY' on GSE Accessories means that catastrophic errors occurred in the software, a trap error may occur and freeze the display with address information. Press any key five seconds after viewing message to reboot the unit.
Why does my GSE Accessories show 'Tare ~ Error'?
The message 'Tare ~ Error' on your GSE Accessories indicates a negative tare attempt was made when disabled (P440 enabled).
What does 'Code 05' mean on my GSE Accessories?
If the GSE Accessories display shows 'Code 05', it means a zero attempt was made beyond that allowed by P118.
What does 'Add ~ Load!' mean on GSE Accessories?
If 'Add ~ Load!' is displayed after performing a count sample on your GSE Accessories, this message indicates that a larger sample size is required.
What does 'Re- ~ Boot!' mean on GSE Accessories?
The message 'Re- ~ Boot!' on GSE Accessories means that EEPROM data could not be read and the unit is attempting a power-up reset.
General| Display Type | TFT LCD |
|---|---|
| Touch Panel | Yes |
| Touch Technology | Resistive |
| Power Supply | 24 VDC |
| Operating Temperature | 0°C to 50°C |
| Storage Temperature | -20°C to 60°C |
| Interface | Ethernet |
| Humidity | 10% to 90% non-condensing |
| Protection Level | IP65 |
| Operating Voltage | 24V DC ±10% |
To Next Page
