What to do if my GSE Touch Panel displays 'Trans~Hold1'?
This message on the GSE Touch Panel indicates that data transmission is being blocked because of a deasserted handshake on communication port 1. To resolve this, press the [ZERO] or [CLR] button to stop the transmission and then check P204.
What to do if my GSE Touch Panel displays 'Trans~Hold2'?
This message on the GSE Touch Panel indicates that data transmission is being blocked because of a deasserted handshake on communication port 2. To resolve this, press the [ZERO] or [CLR] button to stop the transmission and then check P204.
What does 'Bit-Er' mean on GSE Accessories?
The message 'Bit-Er' on GSE Accessories means that the stop bit of a received character did not occur when expected. Verify that protocol (P200 – P204) matches that of the connected device.
What to do if GSE Accessories display shows 'Code03 Over Load'?
If the GSE Accessories display shows 'Code03 Over Load', perform the same checks as for an 'under load' situation.
What does 'Add ~ Load!' mean on GSE Accessories?
If 'Add ~ Load!' is displayed after performing a count sample on your GSE Accessories, this message indicates that a larger sample size is required.
What does 'Code 05' mean on my GSE Accessories?
If the GSE Accessories display shows 'Code 05', it means a zero attempt was made beyond that allowed by P118.
Why does my GSE Accessories show 'Tare ~ Error'?
The message 'Tare ~ Error' on your GSE Accessories indicates a negative tare attempt was made when disabled (P440 enabled).
What does 'Add ~ Load!' mean during calibration on GSE Accessories?
During calibration, the message 'Add ~ Load!' on GSE Accessories means that the calibration weight is less than 0.1% of capacity. More weight is required.
What does 'Prtcl ~ Error' mean on GSE Accessories?
The message 'Prtcl ~ Error' on GSE Accessories means that the existing protocol is invalid. The following are not allowed: ? P201 = 7 data bits, P202 = no parity, P203 = 1 stop bit ? P201 = 8 data bits, P202 = even parity, P203 = 2 stop bits.
What does 'Code00' mean on my GSE Accessories?
If the GSE Accessories display shows 'Code00', it indicates an EPROM problem detected during power-up (U2).
General| Display Type | TFT LCD |
|---|---|
| Touch Panel | Yes |
| Touch Technology | Resistive |
| Power Supply | 24 VDC |
| Operating Temperature | 0°C to 50°C |
| Storage Temperature | -20°C to 60°C |
| Interface | Ethernet |
| Humidity | 10% to 90% non-condensing |
| Protection Level | IP65 |
| Operating Voltage | 24V DC ±10% |
To Next Page
