What to do if my GSE Touch Panel displays 'Over load'?
If your GSE Touch Panel displays 'Over load', perform the same checks as you would for an 'under load' situation. This involves inspecting the load cell wiring.
What to do if my GSE 350 displays 'Under Load'?
If your GSE Touch Panel displays 'Under Load', check the load cell wiring.
What does it mean when my GSE 350 Touch Panel displays 'Input signal greatly exceeds the valid range'?
This message indicates that the input signal is far beyond what is expected. To resolve this, check the load cell connection of your GSE Touch Panel.
What does 'Receive buffers capacity was exceeded' mean on my GSE 350 Touch Panel?
The message 'Receive buffers capacity was exceeded' on your GSE Touch Panel indicates a handshaking problem.
What to do if data transmission is inhibited on communication port 1 of my GSE 350 Touch Panel?
If data transmission is inhibited due to a deasserted handshake on communication port 1 of your GSE Touch Panel, press or to abort transmission.
What to do if data transmission is inhibited on communication port 2 of my GSE Touch Panel?
If data transmission is inhibited due to a deasserted handshake on communication port 2 of your GSE Touch Panel, press or to abort transmission.
What does it mean if my GSE 350 Touch Panel displays 'A checksum error occurred during power-up'?
If your GSE Touch Panel displays 'A checksum error occurred during power-up', all annunciators are lit. This means that the EPROM integrity test failed or the EPROM is improperly seated.
What does it mean if my GSE 350 displays 'An error occurred when reading setup data from the EEPROM during power-up'?
If your GSE Touch Panel displays 'An error occurred when reading setup data from the EEPROM during power-up', all parameters are set to factory default.
What does 'EEPROM data could not be read' mean on my GSE Touch Panel?
If your GSE Touch Panel displays 'EEPROM data could not be read', the device is attempting a power-up reset.
What should I do if my GSE 350 displays 'Problem with A/D chip detected'?
If your GSE Touch Panel displays 'Problem with A/D chip detected', disconnect any options installed and re-power the unit.
General| Display Type | TFT LCD |
|---|---|
| Touch Panel | Yes |
| Touch Technology | Resistive |
| Power Supply | 24 VDC |
| Operating Temperature | 0°C to 50°C |
| Storage Temperature | -20°C to 60°C |
| Interface | Ethernet |
| Humidity | 10% to 90% non-condensing |
| Protection Level | IP65 |
| Operating Voltage | 24V DC ±10% |
To Next Page
