GSI Group - Laser Division
JK300HP/JK300P/JK125P
Issue 2.0 Pre-installation and User Manual
Part No: 1EA300E01 Page 57 of 172
4. Installation
4.1 Equipment Warranty
Installation of the JK300HP/JK300P/JK125P Series Laser must be carried out by an
Authorised GSI Group - Laser Division Engineer (or a GSI Group - Laser Division certified
engineer). Installation carried out by personnel other than the aforementioned, will render
the equipment warranty void.
4.2 Installation Procedure
Installation of the laser system is estimated to take approximately two days but no more than
three days and includes the following:
• Equipment checks. Check system laser is intact, in good working condition and
inspection of site service connection.
• Site location of laser system.
• Pre-installation check of laser system.
• Mains power connection (or inspection if carried out by customer).
• External water supply connection (or inspection if carried out by customer).
• Laser power up and system check.
• Fibre installation, including routing and alignment.
Provision of customer operator training:
• Basic safety instruction.
• Laser start-up and shut-down sequence.
• GUI Interface.
• Arc-lamp replacement.
• Rear mirror tuning.
• Cover slide replacement.
• Finding focus.
On completion of installation, the installation engineer and customer are to sign a certificate
of completion to verify that:
• The Customer is satisfied with the laser installation.
• The Customer is competent to operate the laser.
Petitioners Canadian Solar Inc. and Canadian Solar (USA) Inc.
Ex. 1025, p. 57
To Next Page
Loading...
Need help?
General
