Need help?Do you have a question about the GSi TYMPSTAR 2 and is the answer not in the manual?
General| Ipsilateral Reflex Frequencies | 500 Hz, 1000 Hz, 2000 Hz, 4000 Hz |
|---|---|
| Storage Temperature | -20°C to 60°C |
| Power Supply | 100-240 VAC, 50/60 Hz |
| Type | Tympanometer |
| Frequency | 226 Hz, 678 Hz |
| Operating Temperature | 15°C to 35°C |
Technical specifications for the GSI TympStar Version 1 instrument.
Technical specifications for the GSI TympStar Version 2 instrument.
Overview of the instrument's front panel controls including hardkeys and softkeys.
Summarized procedures for conducting tests on the TympStar Version 1.
Summarized procedures for conducting tests on the TympStar Version 2.
Step-by-step guide for performing a Tymp diagnostic test on Version 2.
Procedures and requirements for preparing the instrument for calibration.
General procedures for calibrating the TympStar using controls.
Specific calibration procedures for the TympStar Version 1.
Specific calibration procedures for the TympStar Version 2.
Procedures for calibrating the pressure system.
General steps for disassembling the instrument.
Detailed instructions for removing the analog board.
Procedure for safely removing the pump assembly.
Instructions for disconnecting and removing the power supply.
Steps for disconnecting and removing the printer board.
Procedures for measuring system power supply voltages.
List and descriptions of error codes generated by the Control Processor.
To Next Page
