12
Slide the filter onto the inner shroud. Slide the filter and inner shroud into the filter
housing.
Replacing the filters
If the brush bar jams during use, the product
will stop and the LEDs will appear red. You will
need to remove and clean the brush bar.
The product will not re-start until the red lights
go out. This will take ten seconds.
If the problem persists, follow the
troubleshooting instructions on page 15.
Removing and cleaning the brush bar / jam or fault
10
seconds
5012_System_K9_UF_manual_aw.indd 125012_System_K9_UF_manual_aw.indd 12 18/05/2021 16:3418/05/2021 16:34
To Next Page
Loading...
