helpline 01905 345891 email support@greytechnology.co.uk web www.gtechonline.co.uk
15
Using your Branch Cutter*
THE SAFETY WARNINGS AT THE FRONT OF THIS MANUAL
SHOULD BE OBSERVED FOR ALL ATTACHMENTS.
Hold the trimmer with both hands. Stand in a secure and stable position.
WARNING: do not overload the Branch Cutter.
Attempting to force the branch cutter to cut may damage the motor. Cut thick branches in
stages with several lights cuts as this will help reduce the load on the motor.
If the blade gets jammed into a branch pull it out by pulling it straight back. Do not twist and
lever it out, this could bend or break the blade!
WARNING: DO NOT CUT DIRECTLY OVERHEAD DANGER OF FALLING OBJECTS!
WARNING: ALWAYS WEAR EYE PROTECTION WHEN USING THE BRANCH CUTTER
WARNING: When transporting or storing the trimmer always t the protective blade guard.
When not in use remove the branch cutter attachment from the trimmer.
Always take care to avoid cutting into objects such as wire, which could cause damage to the
cutting blade and drive.
When cutting branches overhead cut the outer parts of the branch off rst. When cutting a
branch too close to the tree, the weight of the branch may clamp the blade in the cut. Avoid
this, as it could damage the blade and drive.
Feed branches or cutting material into the blade on the left side of the blade close to the “support”.
*Only included with some models. All attachment tools are available to purchase
separately from www.gtechonline.co.uk or 01905 345891.
HT04 GenericManual09QVC.indd 15 23/12/2009 11:26
To Next Page
Loading...