Environment & Product Recycling
helpline 01905 345891 email support@greytechnology.co.uk web www.gtechonline.co.uk
18
The symbol indicates that this product is covered by legislation for waste electrical and
electronic products (EN2002/96/EC) When the product has reached the end of its life please
do not dispose of it with general household waste. Consider the environment and take it to a
recognised recycling facility.
The product contains a NiCd battery which should not be disposed with general household waste.
The battery should be removed from the product and be disposed of properly at a recycling facility.
Call your local council, civic amenity site, or recycling centre
for information on the disposal and recycling of electrical products.
Alternatively visit www.recycle-more.co.uk for advice on
recycling and to nd your nearest recycling facilities.
Troubleshooting
PROBLEM POSSIBLE REASON POSSIBLE SOLUTION
Tool fails to
operate
1. Battery flat
2. Battery pack not fully pushed
into product
3. Faulty switch
1. Recharge battery
2. Push battery pack into product
3. Switch in handle will ‘click’ when
operated if operating correctly
Battery not
charging
1. Charger cord not well
connected to charging stand
2. Battery not fully pushed into
charging stand
3. Charger faulty
1. Check charger connector is
correctly fitted to charging stand
2. Push battery fully into charging stand.
3. Charger should feel warm to touch
when charging battery
Cutting blade
excessively hot
1. Lack of lubrication
2. Cutting blade damaged
3. Cutting blade blunt
1. Clean/lubricate blade
2. Replace blade
3. Replace blade
Blade will not move.
Do not hold switch
on when blade is
jammed
1. Battery flat
2. Blade teeth jammed
or damaged
3. Blade corroded
1. Recharge battery
2. Remove obstructions from the
blade (switch tool off!)
3. Replace blade
Cutting time low 1. Blade needs lubrication
2. Blade needs cleaning
3. Overloading motor
4. Battery not fully charged.
5. Battery no longer holding charge
1. Lubricate blade
2. Clean and lubricate blade
3. Use lighter cutting action and cut
in several stages
4. Fully charge battery
5. Replace battery
Should you experience any problems please do not return the product to the shop.
For any help, technical assistance, or spare parts please contact the Gtech helpline.
Tel: 01905 345891 email: support@greytechnology.co.uk
HT04 GenericManual09QVC.indd 18 23/12/2009 11:26
To Next Page
Loading...