11
The sprung terminal will need liing to expose
the hole, ensure the wire is full inserted before
releasing the red terminal clip
You will need to strip the plastic sheath
from the end of the wire before connecting.
Twisting the exposed wires aer exposing
helps ensure a good connection.
The charge stand has a hood at the back
(shown in grey) that hinges forwards.
Push the charge station hood forward to
uncover the wiring terminals.
4719_Robot_Mower_manual_aw3.indd 114719_Robot_Mower_manual_aw3.indd 11 20/04/2021 16:2220/04/2021 16:22
To Next Page
Loading...
