Installation and Use
Guardian Fall Protection 6305 S. 231st St., Kent, WA 98032 USA phone: (800) 466-6385 fax: (800) 670-7892 www.guardianfall.com
4
Guardian Fall Protection recommends that a back-up fall protection
system, functional in Fall Arrest applications, be used in conjunction
with all Chain Positioning Lanyards. Competent Person must make
final determination regarding use of back-up fall protection system.
!
WARNING
1. Connect back-up fall protection system, deemed compatible by a Competent Person, to harness dorsal
D-ring. Follow all manufacturer’s instructions for all components of back-up system. Ensure sufficient fall
clearance exists at all work areas, and that all applicable safety regulations are followed at all times.
Quick Link Carabiners must only be used to connect Rebar Positioning
Device chain links for purposes of adjusting length of chain.
Both Chain Legs must always be adjusted to same length.
NEVER make any connections to Quick Link Carabiners.
!
WARNING
Rebar Hook fully
closed and
locked around
structural rebar.
3. Connect Rebar Hook to structural rebar; ensure hook fully closes and locks around rebar. If climbing, ensure
that 100% tie-off is maintained at all times.
2. If applicable/necessary, adjust length of Chain Legs by using Quick Link Carabiners to connect chain links.
NEVER cross-connect Chain Legs. Then, connect Chain Positioning Lanyard Snap Hooks to harness side D-rings OR
harness shoulder D-rings. Ensure Snap Hooks fully close and lock around D-rings. MAXIMUM 1 connection per
D-ring.
01617
01616
01608
01610
To Next Page
Loading...
Need help?
General
