What to do if Guest 16102 status GREEN LED is ON when the battery is not fully charged?
If the Guest Battery Charger's green LED is on even when the battery isn't fully charged, it could be due to one of two reasons: 1. The 8-hour absorption stage timer has expired. Load test the batteries and replace if necessary. 2. One or more cells are defective or damaged. Turn off all DC equipment while charging.
What to do if Guest 16102 status RED LED is blinking 1 time?
If the Guest Battery Charger's red LED is blinking once, indicating no battery is present, here are a few potential causes and solutions: 1. The DC output fuse is open. Replace the DC output fuse with an equivalent size. 2. There are faulty or contaminated terminal connections. Clean, tighten, or repair all terminal connections. 3. One or more cells are defective or damaged. Load test the batteries and replace them if necessary. 4. There is reverse polarity across the battery. Replace the DC output fuse and correct the charger lead orientation. 5. No battery is present. Connect DC output connections to the battery.
Why is Guest Battery Chemistry Indicator not identifying the correct battery chemistry?
If the Guest Battery Charger's battery chemistry indicator isn't correctly identifying the battery chemistry, it could be due to: 1. AC power was applied before battery chemistry selection was made. Disconnect both AC and DC power. Reconnect DC connections to the battery and follow section Setting Up the Battery Chemistry. 2. There was an interruption to both AC and DC battery power. Disconnect both AC and DC power. Reconnect DC connections to the battery and follow section Setting Up the Battery Chemistry.
What to do if Guest 16102 Battery Charger status RED LED is blinking 5 times?
If the Guest Battery Charger's red LED is blinking 5 times, it indicates a microprocessor check sum failure. Return charger to the Guest Service Dept.
What to do if Guest 16102 status RED LED is blinking 3 times?
If the Guest Battery Charger's red LED blinks 3 times, it indicates the 14-hour bulk timer has expired. This could be due to several reasons: 1. One or more defective or damaged cells. You should load test the batteries and replace them if necessary. 2. The charger has reduced its output voltage below the normal level because of a DC overload or a DC short. Remove the source of the overload or short. Disconnect the charger’s black (NEGATIVE) ring terminal from the battery. Reapply AC power, and the green LED only should now light. 3. On-board DC systems are drawing more current than the charger can replace. Turn off all DC equipment while charging. 4. Excessive ambient temperature has forced the charger to cut back output current to protect itself. Determine the cause of the excessiv...
Important warnings about battery types and explosive gases during operation.
DANGER and CAUTION notes regarding AC connection and grounding.
Adheres to personal safety precautions when installing or working with the chargers.
Precautions to read before charging a battery with the charger.
Guidelines for selecting an appropriate mounting location for the charger.
Instructions for mounting the charger using appropriate hardware.
Instructions for making correct polarity DC connections to the battery.
How to set the battery chemistry for each individual charger output.
Connect the AC plug into a GFCI protected receptacle.
Describes the charging process for 6amp and 10amp models using LED indicators.
Troubleshooting steps for a charger with a blinking red LED (3 times) indicating timer expiration.
Troubleshooting steps for a charger with a blinking red LED (5 times) indicating program memory issues.
Troubleshooting steps for a charger with a blinking red LED (1 time) indicating no battery present.
Troubleshooting for a green LED that stays on when the battery is not fully charged.
Troubleshooting for incorrect battery chemistry identification by the indicator.
General| Brand | Guest |
|---|---|
| Model | 16102 |
| Category | Battery Charger |
| Language | English |
To Next Page
