EasyManua.ls Logo

Guldmann GH3 - GH3 Use and Conditions; Manufacturer Information; Intended Purpose and Area of Use; Conditions for Use

Guldmann GH3
56 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6
© Guldmann GB/US-12/2018 • # 550383_9.00
© Guldmann GB/US-12/2018 • # 550383_9.00
1.04 Important/Precautions
Read the instructions carefully before using the GH3 and in connection
with cleaning and service of the hoist.
The GH3’s maximum load must never be exceeded.
The GH3 may only be used to lift a person.
The red strap for the emergency stop and the emergency lowering must
be adjusted to the helpers reach, and must not be removed.
The GH3 must not be used where there is a risk of it being splashed with
water.
If a defect appears during use of the GH3, stop using the hoist and contact
the Guldmann Service Team for repairs.
The GH3 is controlled by a microprocessor PCB, which can be damaged by
static electricity if touched without the necessary precautions, (see point 1.08)
The electronics may only be serviced by Guldmann approved service
technicians.
The lifting hanger must not be mounted or replaced when the GH3 hoist is
positioned over the patient.
Do not modify this equipment without authorization of the manufacture
The GH3 needs special precautions regarding EMC and needs to be installed
and put into service according to the EMC information provided in Chapter 11
EMC Information.
Portable and mobile RF communications equipment can affect the GH3.
The use of ACCESSORIES, transducers and cables other than those
specied, with the exception of transducers and cables sold by Guldmann A/S
of the GH3 as replacement parts for internal components, may result in
increased EMISSIONS or decreased IMMUNITY of the GH3.
The GH3 should not be used adjacent to or stacked with other equipment
and that if adjacent or stacked use is necessary, the GH3 should be observed
to verify normal operation in the conguration in which it will be used.
Transport of this equipment should only be undertaken after conditions
described in section 3.00 (Environmental conditions).
Re: EMC
If electromagnetic or other inuences occur between this product and other
products, these products must not be used together.

Other manuals for Guldmann GH3

Related product manuals