GW Instek GDS-1000-U Series - Page 16

GDS-1000-U Series User Manual
16
Utility key
Utility
Configures the Hardcopy function
(page 101), shows the system
status (page 94), selects the menu
language (page 94), runs the self
calibration (page 116), configures
the probe compensation signal
(page 117), and selects the USB
host type (page 93).
Help key
Help
Shows the Help contents on the
display (page 44).
Autoset key
Autoset
Automatically configures the
horizontal, vertical, and trigger
settings according to the input
signal (page 46).
Measure key
Measure
Configures and runs automatic
measurements (page 52).
Save/Recall key
Save/Recall
Saves and recalls images,
waveforms, or panel settings
(page 96).
Hardcopy key
Hardcopy
Stores images, waveforms, or
panel settings to USB (page 101).
Run/Stop key
Run/Stop
Runs or stops triggering (page 47).
Trigger level knob
LEVEL
TRIGGER
Sets the trigger level (page 85).
Trigger menu key
MENU
Configures the trigger settings
(page 85).
Single trigger key
SINGLE
Selects the single triggering mode
(page 91).
Trigger force key
FORCE
Acquires the input signal once
regardless of the trigger condition
at the time (page 91).