Need help?Do you have a question about the GW Instek GDS-820 and is the answer not in the manual?
General| Brand | GW Instek |
|---|---|
| Model | GDS-820 |
| Category | Test Equipment |
| Language | English |
Pinout details for the RS-232 connector for proper connectivity.
Step-by-step guide for connecting the oscilloscope to a PC via RS-232.
Step-by-step guide to configure the GPIB address for communication.
Methods to test and verify the GPIB connection using utility software.
Essential commands like identification (*IDN?), reset (*RST), and status clearing (*CLS).
Commands for setting record length, acquisition mode, and averaging.
Commands to configure trigger level, mode, source, and synchronization.
Commands to perform various waveform measurements (e.g., frequency, voltage).
Table listing SCPI error codes and their explanations.
To Next Page