4-5-6. Range Hold
If a DUT is removed from the test cable or fixture during the “Continuous” mode,
the feature of “Range Hold” can avoid range switching. Due to the test time can
be reduced, “Range Hold” is a useful utility for repetitive devices measurement.
User can just press compound key 0 to select the feature of “Range Hold”. To
disable this feature, press the same key again.
4-5-7. Averaging
If this function is enable, the testing time will multiple by the number of tests
(from 1 to 255). Hence, the accuracy can be enhanced. The measurement time
will be increased to the contrary. The programming of “Averaging” is as follows
(Figure 4-11):
l Press MENU key.
l Press F3 key to select “SETTING” menu.
l Press F3 key to select “AVGE” menu.
l Input the desired value via the numeral keys.
l Press ↵ key
l After the BAR at the bottom of LCD monitor is filled to the full, the
“Averaging” input is done.
To Next Page
Loading...
