GW Instek MFG-2120MA - Establishing a Remote Connection; Configure USB Interface; Configure LAN Interface

REMOTE INTERFACE
249
Establishing a Remote Connection
The MFG-2000 supports USB remote connections.
Configure USB interface
USB
configuration
PC side connector
Type A, host
MFG-2000 side
connector
Type B, slave
Speed
1.1/2.0 (full speed)
Panel Operation
1. Download and install the USB driver from the
GW Instek website, www.gwinstek.com. Go to
the Product > Signal Sources > Arbitrary
Function Generators > MFG-2000 product page
to find the USB driver setup file.
Double click the driver file and follow the
instructions in the setup wizard to install the
driver.
2. Press the Utility key followed
by Interface (F2) and USB
(F2).

a
B
3. Connect the USB cable to the
rear panel USB B (slave) port.
Configure LAN interface
LAN
configuration
MAC Address
Domain Name
Instrument Name
DNS IP Address
User Password
Gateway IP Address
Instrument IP Address
Subnet Mask