GW Instek MFG-2120MA - Source[1|2|3]:Pwm:source

MFG-2000 Series User Manual
324
Note
Burst or sweep mode will be disabled if PWM
modulation is enabled. As only one modulation is
allowed at any one time, other modulation modes
will be disabled when PWM modulation is
enabled.
Syntax
SOURce[1|2|3]:PWM:STATe {OFF|ON}
Example
SOUR1:PWM:STAT ON
Enables PWM modulation
Query Syntax
SOURce[1|2|3]:PWM:STATe?
Return Parameter
0
Disabled (OFF)
1
Enabled (ON)
Example
SOUR1:PWM:STAT?
ON
PWM modulation is currently enabled.
SOURce[1|2|3]:PWM:SOURce
Source Specific
Command
Description
Sets or queries the PWM source as internal or
external. Internal is the default source.
Note
If an external PWM source is selected, the duty
cycle/pulse width is controlled by the MOD
INPUT terminal on the rear panel.
The RF channel supports only the internal
modulation mode.
Syntax
SOURce[1|2|3]:PWM:SOURce {INTernal|EXTernal}
Example
SOUR1:PWM:SOUR EXT
Sets the PWM source to external.
Query Syntax
SOURce[1|2|3]:PWM:SOURce?
Return Parameter
INT
Internal
EXT
External
Example
SOUR1:PWM:SOUR? INT