GW Instek PEL-2002 - Page 152

PEL-2000 Series User Manual
152
3. Use the Selector knob to
highlight Value.
4. Press the Selector knob to edit
the Value, then turn to increase
or decrease the value.
OR
5. Use the number pad to enter a
number.
6. Press the Selector knob or Enter
to confirm selection.
7. Repeat for rising and falling
Slew Rate and Duration Time.
Add Point
8. To add an extra point after the
current point, press Add Point
(F1).
Range 001~120
Note
Add Point will insert a new point directly after the
current point. The value of the current/resistance of
the inserted point will be the average of the point
before and after. All other settings will remain
unchanged.
Delete Point
9. To delete the current point, press
Delete Point (F2).
Edit previous
point
10. Use the selector knob to change
the current point number.