GW Instek PSU 40-38 - PSU Factory Default Settings

PSU Series User Manual
194
PSU Factory Default Settings
The following default settings are the factory configuration settings
for the power supply.
For details on how to return to the factory default settings, see page
45.
Initial Settings
Default Setting
Output
Off
LOCK
0 (Disabled)
Voltage
0V
Current
0A
OVP
1.1 X Vrate
OCP
1.1 X Irate
Normal Function
Settings
Setting
Default Setting
Output ON delay time
F-01
0.00s
Output OFF delay time
F-02
0.00s
V-I mode slew rate select
F-03
0 = CV high speed priority (CVHS)
Internal resistance
setting
F-08
0.000Ω
Bleeder circuit control
F-09
1 = ON
Buzzer ON/OFF control
F-10
1 = ON
OCP Delay Time
F-12
0.1 sec
Current Setting Limit
F-13
0 = OFF
Voltage Setting Limit
F-14
0 = OFF
Display Memory
parameter when recalling
F-15
0 = OFF
Auto Calibration Parallel
Control
F-16
0 = Disable
Measurement Average
Setting
F-17
0 = Low
Alarm Recovery and
Output Status
F-18
0 = Safe Mode
Lock Mode
F-19
0:Lock Panel, Allow Output OFF
USB / GPIB setting
Setting
Default Setting
Setup Rear USB Speed
F-22
2 = Auto Detect Speed
GPIB address
F-23
8
GPIB Enable/Disable
F-24
1 = Enable GPIB