GW Instek PSW 30-36 - USB Remote Control Function Check

PSW Series User Manual
146
F-45 = 128
Subnet Mask part 3 of 4
F-46 = 0
Subnet Mask part 4 of 4
F-47 = 172
Gateway part 1 of 4
F-48 = 16
Gateway part 2 of 4
F-49 = 21
Gateway part 3 of 4
F-50 = 101
Gateway part 4 of 4
F-51 = 172
DNS Address 1 of 4
F-52 = 16
DNS Address 2 of 4
F-53 = 1
DNS Address 3 of 4
F-54 = 252
DNS Address 4 of 4
F-57 = 1
Enable Sockets
Note
The socket function is only available for firmware
version V1.12 or above. See page 112 to check your
firmware version number.
USB Remote Control Function Check
Functionality
check
Invoke a terminal application such as Realterm.
The PSW will appear as a COM port on the PC.
To check the COM port No, see the Device
Manager in the PC. For WinXP; Control panel
→ System → Hardware tab.
Note
If you are not familiar with using a terminal
application to send/receive remote commands via
a USB connection, please page 147 (Using
Realterm to Establish a Remote Connection) for
more information.
Run this query command via the terminal after
the instrument has been configured for USB
remote control (page 142).
*idn?
This should return the Manufacturer, Model
number, Serial number, and Firmware version
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com