GW Instek SPS-606 - SETUP; Installation, Power, and OVP Setup

To Next Page

To Previous Page

SETUP

This chapter describes how to properly power up

and configure SPS before operation. For checking

the functionality, refer to the Performance

verification chapter, page27.

Installation Installation Location ....................................... 18

Power Power Up ........................................................ 18

OVP Over Voltage Protection Set Up ....................... 19

Load Wire Load Cable Connection ................................... 20

Current Level Setting the Current Level ................................. 22

Remote Control Setting the Remote Control ............................. 23

Other manuals for GW Instek SPS-606