H3C MSR Series User Guide

19
Logging in to Windows
The OAP/OAPS module does not have an HMI, so you must log in from the PC to the OAP/OAPS
module by using Remote Desktop Connection through the Ethernet port on the module after the Windows
operating system is started.
After you log in to the Windows operating system, you can customize the OAP/OAPS module, just as
you do on a PC installed with Windows operating system.
Figure 5 Log in to the OAP/OAPS module through Remote Desktop Connection
Customization guidelines
Note the following guidelines when you customize the OAP/OAPS module:
• Do not disable the Remote Desktop function.
• Do not update the driver for the GE port on the device panel.
• Do not change the IP address of the GE port on the device panel. If you change the IP address of
the GE port, Remote Desktop Connection will be terminated, and you have to use the new IP
address to reestablish a remote desktop connection.
• Disable the Sleep and Standby functions for the OAP/OAPS module.

H3C MSR Series Specifications

General

Category	Network Router
IPv6 Support	Yes
Dimensions	Varies by model
Weight	Varies by model
Product Type	Modular Router
Ports	Varies by model
WAN Interfaces	Varies by model
Firewall	Yes
QoS	Yes
Wireless Support	Varies by model
USB Ports	Varies by model
Console Port	Yes
Power Supply	Varies by model
Redundancy	Varies by model
Operating Temperature	0°C to 45°C
Storage Temperature	-40°C to 70°C
Humidity	5% to 95% non-condensing
Series	MSR
Certifications	CE, FCC, RoHS