H3C MSR Series Probe Command Reference

16
Voice probe commands
dsp-capture pcm
Use dsp-capture pcm to capture DSP PCM packets on a voice interface.
Syntax
dsp-capture pcm if-name { start | stop }
Views
Probe view
Predefined user roles
network-admin
network-operator
Parameters
if-name: Specifies a voice interface.
start: Starts capturing packets.
stop: Stops capturing packets.
Usage guidelines
The router can capture DSP PCM packets only on one voice interface. To capture packets on another
voice interface, you must stop capturing packets on the previous voice interface.
display hardware internal dspmem
Use display hardware internal dspmem to display DSP memory information.
Syntax
display hardware internal dspmem if-name dsp-num dsp-addr
Views
Probe view
Predefined user roles
network-admin
network-operator
Parameters
if-name: Specifies a voice interface.
dsp-num: Specifies a DSP by its number in the range of 0 to 15.
dsp-addr: Specifies a DSP memory address in the range of 0x00000 to 0x27FFF.

H3C MSR Series Specifications

General

Category	Network Router
IPv6 Support	Yes
Dimensions	Varies by model
Weight	Varies by model
Product Type	Modular Router
Ports	Varies by model
WAN Interfaces	Varies by model
Firewall	Yes
QoS	Yes
Wireless Support	Varies by model
USB Ports	Varies by model
Console Port	Yes
Power Supply	Varies by model
Redundancy	Varies by model
Operating Temperature	0°C to 45°C
Storage Temperature	-40°C to 70°C
Humidity	5% to 95% non-condensing
Series	MSR
Certifications	CE, FCC, RoHS