19
Main board probe commands
display hardware internal pcicfg
Use display hardware internal pcicfg to display the contents of the PCI configuration space, including the
contents of the PCI-E configuration space.
Syntax
display hardware internal pcicfg slot-num pci-num bus-num dev-num func-num pci-offset width-num
Views
Probe view
Predefined user roles
network-admin
network-operator
Parameters
slot-num: Specifies a slot number. It must be 0 for an MSR 2600 or MSR 3600, and must be in the range
of 0 to 2 for an MSR 5600.
pci-num: Specifies the number of the system's PCI-E controller (RC), in the range of 0 to 1. The router can
use up to two RCs.
bus-num: Specifies the PCI bus number in the range of 0 to 255.
dev-num: Specifies the PCI device number in the range of 0 to 31.
func-num: Specifies the PCI function number in the range of 0 to 7.
pci-offset: Specifies the PCI configuration register offset in the range of 0x0000 to 0xFFFF.
width-num: Specifies the PCI configuration access bit width in bytes. Valid values include 1, 2, and 4.
Usage guidelines
This command reads the PCI configuration space, including the PCI-E configuration space. To use this
command, you must do the following:
• Obtain the PCI device's PCI bus number, device number, and function number.
• Specify an offset for the command.
display hardware internal access-space
Use display hardware internal access-space to display hardware space information.
Syntax
display hardware internal access-space slot-num acc-addr width-num
Views
Probe view
To Next Page
Loading...
Need help?
General
