H3C MSR3600-28 - Page 53

52
CAUTION:
To avoid device damage, you
must perform the following steps if you fail to start the MSR3610-
G or
MSR3620
-G router:
1.
Power off the router.
2.
Remove the label from the Micro SD card slot.
3.
Reinstall the MicroSD card.
4.
Restart the router.
For a router starting with empty configuration, you must press Ctrl+D to access the CLI.
To access the router for the first time:
1. Verify that the installation and configuration environment is as described in "Verifying the
installation."
2. Power on the router.
3. During the booting process, verify the following items:
 The LEDs on the front panel are in the states as described in Table 2.
Table 2 LED states when the router is operating correctly
LED
State
Description
PWR Steady green The power module is supplying power correctly.
SYS Slow flashing green The router is operating correctly.
 The configuration terminal displays information correctly.
The router first initializes its memory at startup and then runs BootWare.
System is starting...
Press Ctrl+D to access BASIC-BOOTWARE MENU...
Press Ctrl+T to start heavy memory test
Booting Normal Extended BootWare........
The Extended BootWare is self-decompressing....Done.
****************************************************************************
* *
* H3C MSR36-40 BootWare, Version 1.60 *
* *
****************************************************************************
Copyright (c) 2004-2018 New H3C Technologies Co., Ltd.
Compiled Date : Dec 23 2015
CPU ID : 0x2
Memory Type : DDR3 SDRAM
Memory Size : 2048MB
BootWare Size : 1024KB
Flash Size : 8MB
cfa0 Size : 247MB
CPLD Version : 2.0
PCB Version : 2.0
BootWare Validating...