7
4. Connecting the power cord 连接电源线
• Use the power cord provided with the power supply for connection. The
power cord provided with the power supply uses a C15 connector that is
designed to withstand high temperatures. 请使用电源模块标配的电源线
进行连接，该电源线采用 C15 接口（耐高温）。
Provide a separate circuit breaker for each power cord. 请保证电源线有
独立的输入断路器。
• Before connecting a power cord, make sure the circuit breaker for the
power feed is turned off. 连接电源线前，请将需要连接电源线的输入端断
路器置于断开状态。
(1) Connect the female connector of the power cord to the power input receptacle
on the power supply. 将电源线带插孔的一端插到电源模块的输入插口上。
(2) Use a cable tie to secure the power cord to the handle of the power supply. 用
可拆卸式扎带将电源线固定到电源模块的拉手处，以防电源线脱落。
5. Removing the power supply 拆卸电源模块
• To avoid bodily injury or switch damage, strictly follow the procedure
described in this section to remove the power supply. 请严格按照如下
操作顺序拆卸电源模块，否则可能会造成设备损坏或者人身伤害。
• If you are not to install a new power supply after removing the old one,
install a filler panel in the slot in time. 如果该电源插槽中不再安装电源模
块，请将假面板安装到该插槽上，以免灰尘进入机箱。
To Next Page
Loading...
Need help?
General